![vertical-saws](https://ttarp.com/hubfs/TTARP/images/vertical-saws.png)
Automatic Vertical Saw Options
Ttarp band saws are available with various options and accessories to provide you with fabricating equipment designed to meet your needs. Contact us if you have a specific challenge or application requirements.
Download Specification Sheet:
![image2](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image2.jpg)
![image3](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image3.jpg)
![image2](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image2.jpg)
![image3](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image3.jpg)
Option A – 50” Cutting Head
- Nominal 48” bun height accomodated. Standard head is 40”
- Note: Automatic stoppage with blade break, soft start on blade via VFD
![image9](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image9.jpg)
![image9](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image9.jpg)
Option B – 67” Table (Outside Blade)
- 49” is standard table outside the blade
- Light curtain at operator access, dynamic blade stoppage if light curtain broken
![image7](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image7.jpg)
![image7](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image7.jpg)
Option C – 24” Leaf Table
- 24” additional outside blade with hinges and hinged pullout leg supports
![image5](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image5.jpg)
![image5](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image5.jpg)
Option D – Interchangeable Blade Guides (Heavy Duty)
- Provides support on the back blade edge for single edge blades
- Useful for higher density foams when using single edge blades ie scalloped, c-tooth, etc
![image6](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image6.jpg)
![image1](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image1.jpg)
![image6](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image6.jpg)
![image1](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image1.jpg)
Option E – Hold Down Bar
- Stabilizes multiple sheets when stacked from sliding against one another during the cutting
- 2-1/4” minimum width of last cut with hold down bar. Easy to remove when not in use
![image8](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image8.jpg)
![image8](https://ttarp.com/hubfs/Vertical%20Saw%20Options/image8.jpg)
Option F – Vacuum Attachment for Dust Control
- Plumbed from blade exit point of foam to back of carriage – travels with blade (back of saw)
- Schedule 40 PVC – 1-1/2” OD vacuum connection
- Shop vac not included